Beyerdynamic Classis BM 32 - Architects Specifications; Classis BM 32 B Specifications; Classis BM 32 SE Specifications; Classis BM 32 W Specifications

To Next Page

To Previous Page

ARCHITECT’S SPECIFICATIONS

The cardioid electret condenser boundary microphone shall be a

high-quality installation microphone for tabletops or ceilings. The

microphone shall be provided with an integrated amplifier and

power supply. The SCUDIO

technology shall eliminate inter-

ferences of other wireless communication devices. The microphone

shall be powered by phantom power between 8 V and 52 V. The

filter in the microphone grille shall eliminate wind and pop noise.

The fully metal housing shall provide a M20 x 1.5 thread with

fastening nut and black metal microphone grille. The delivery shall

include elastic bearing rings to compensate mechanical noise and

vibration. The frequency response shall be 50 Hz - 18 kHz. The open

circuit voltage shall be 19 mV/Pa. The nominal impedance shall be

200 ohms. The lower part of the housing shall provide a 3-pin male

XLR connector. The total length shall be 76 mm [3"], the shaft

length shall be 67 mm [2.6"], the shaft diameter shall be 20 mm

[0.8"] (M20 x 1.5 thread with fastening nut), the head diameter

shall be 30 mm [1.2"], the length of the head shall be 9 mm [0.4"].

The net weight shall be 0.085 kg [0.2 lbs].

Manufacturer: beyerdynamic

Type: Classis BM 32 B

The cardioid electret condenser boundary microphone shall be a

high-quality installation microphone for tabletops or ceilings. The

microphone shall be provided with an integrated amplifier and

power supply. The SCUDIO

technology shall eliminate inter-

ferences of other wireless communication devices. The microphone

shall be powered by phantom power between 8 V and 52 V. The

filter in the microphone grille shall eliminate wind and pop noise.

The fully metal housing shall provide a M20 x 1.5 thread with

fastening nut and a microphone grille with silver metal-look made

of double-layer, fine-meshed acuraLINE

wire mesh. The delivery

shall include elastic bearing rings to compensate mechanical noise

and vibration. The frequency response shall be 50 Hz - 18 kHz. The

open circuit voltage shall be 19 mV/Pa. The nominal impedance

shall be 200 ohms. The lower part of the housing shall provide a

3-pin male XLR connector. The total length shall be 76 mm [3"],

the shaft length shall be 67 mm [2.6"], the shaft diameter shall be

20 mm [0.8"] (M20 x 1.5 thread with fastening nut), the head

diameter shall be 30 mm [1.2"], the length of the head shall be

9 mm [0.4"]. The net weight shall be 0.085 kg [0.2 lbs].

Manufacturer: beyerdynamic

Type: Classis BM 32 SE

The cardioid electret condenser boundary microphone shall be a

high-quality installation microphone for tabletops or ceilings. The

microphone shall be provided with an integrated amplifier and

power supply. The SCUDIO

technology shall eliminate inter-

ferences of other wireless communication devices. The microphone

shall be powered by phantom power between 8 V and 52 V. The

filter in the microphone grille shall eliminate wind and pop noise.

The fully metal housing shall provide a M20 x 1.5 thread with

fastening nut and white metal microphone grille. The delivery shall