30
2.3 Setting up
1. When the microphone is switched on, the battery status indicator will flash for a
moment.
2. As soon as the microphone is switched on, the RF meter on the receiver will illuminate.
The stronger the signal, the more LEDs will illuminate.
3. As soon as an audio signal is transmitted, the AF meter on the receiver will display a
signal. The stronger the signal, the more LEDs will illuminate.
4. When you do not use the microphone, make sure it is switched off. If you do not use the
microphone for several weeks or months, please remove the battery as it can leak after
some time and damage parts of the transmitter.
3
2.4 Maintenance
• Protect the transmitter from humidity, knocks and shock. Avoid dropping the transmitter
at all times.
• For cleaning metal surfaces, use a soft cloth moistened with methylated spirits or
alcohol.
• To clean the integrated foam pop shield, unscrew the microphone basket counter
clockwise.
• Pull out the foam pop shield and clean it under clear running water.
• If necessary, use a mild washing-up liquid.
• Dry it afterwards with a hairdryer or allow it to dry overnight.
• Place the dry pop shield inside the microphone basket and replace the microphone
basket by screwing it on clockwise.
1
To Next Page