Need help?Do you have a question about the Biamp EQ-290 and is the answer not in the manual?
General| Brand | Biamp |
|---|---|
| Model | EQ-290 |
| Category | Stereo Equalizer |
| Language | English |
Controls for filter engagement, boost/cut, frequency, and shelving.
Adjusts the overall gain of the equalizer.
Displays signal level and unit status; controls power.
Power connection and circuit breaker for protection.
Connectors for audio signal input and output.
Terminal strip for floating circuit ground to prevent ground loops.
20 faders adjust gain across 10-octave bands from 32Hz to 16kHz.
Adjusts overall channel gain and enables/disables graphic faders.
Indicates signal clipping, unit status, and controls power.
Power connection and circuit breaker for protection.
Connectors for balanced/unbalanced input and output signals.
30 faders adjust gain across 15 2/3-octave bands from 25Hz to 16kHz.
Controls for overall gain, EQ bypass, tape monitoring, and tape pre/post selection.
Displays signal level, unit status, and controls power.
Power connection and circuit breaker for protection.
Terminal strip for floating circuit ground to prevent ground loops.
Various connectors for line, tape, and general audio signals.
29 faders adjust gain across 1/3-octave bands; gain control adjusts overall channel level.
Controls for EQ bypass and high-pass filter engagement.
Displays signal level, unit status, and controls power.
Power connection and circuit breaker for protection.
Terminal strip for floating circuit ground to prevent ground loops.
Controls and connectors for audio signal input, output, and low-pass filter.
Controls for setting crossover frequency and output levels for high/low frequencies.
Adjusts gain, engages high-pass filter, and shifts frequency range.
Displays signal status, clipping, power status, and controls power.
Power connection and circuit breaker for protection.
Terminal strip for grounding and switch for inverting high frequency phase.
Connectors for high/low frequency audio signal input and output.
Controls for setting crossover frequency and output levels for low/high frequencies.
Adjusts gain, engages HPF, selects crossover mode, and shifts frequency range.
Displays signal status, clipping, power status, and controls power.
Power connection and circuit breaker for protection.
Terminal strip for grounding and switches for inverting high frequency phase.
Connectors for low/high frequency audio signal input and output.
Controls for setting crossover frequencies and output levels for low/mid/high frequencies.
Adjusts gain, engages HPF, selects crossover modes, and shifts frequency ranges.
Displays signal status, clipping, power status, and controls power.
Power connection and circuit breaker for protection.
Terminal strip for grounding and switches for inverting high frequency phase.
Connectors for high/low/mid frequency audio signal input and output.
Adjusts the amount of low, low-mid, high-mid, and high frequencies in the reverb signal.
Controls input drive, output level, and the blend of wet/dry reverb signals.
Indicates drive level, unit status, and controls power.
Power connection and fuse for protection.
Terminal strip for grounding and connector for footswitch control.
Connectors for balanced and unbalanced audio signal input and output.
Adds reverb effect to the in-line signal path after the mixer.
Sends wet signal back to the mixer for blending with dry signal.
Step-by-step guide for connecting the MR140 for wet/dry mixing.
Instructions for setting drive, balance, and EQ controls for optimal reverb.
Outlines conditions voiding the warranty and limitations.
Instructions for returning units and Biamp's service process.
To Next Page