25
English
User’s Manual IUPS-401-B8
Status display and Alarm
Status display Alarm Alarm sound LED
detachable
Normal UPS mode – green
Battery charge (mains mode) – green flashing
UPS battery mode 2 beep sounds every 3 seconds yes red flashing
UPS battery mode (Battery low) 4 beep sounds a second no red flashing (quickly)
Overload (Normal mode) Continuous sound no red
Internal UPS failure 8 beep sounds per 2 sec., no red flashing (quickly)
2 sec. stillness
Overtemperature 8 beep sounds per 2 sec., yes red flashing (quickly)
2 sec. stillness
Battery defect – red flashing (quickly)
Article Interface Load sensor UPS management software
No. switch off
IUPS-401-B8 USB ≤33 W*
UPSilon 2000 and DSUB9 to USB cable
included in delivery (Windows® 7, 8, 10,
Server 2012).
Reboot function
If mains voltage returns after a power failure while Windows® is already shutting down, the UPS switches
the PC off (after the shut-down period) and switches it on again after app. 30 sec…5 minutes depending on
the battery capacity (the higher the capacity, the shorter the restart time). This latency is required to ensure
sufficient energy for a secure shutdown in case of a new power failure. Observe BIOS settings to restart the
mainboard.
* Tolerance of switch-o threshold ≤3 %
For futher information please visit our website www.bicker.de and refer to the article number.
To Next Page
Loading...