2
Safety notices for use of the unit
Read this Manual carefully before using the unit!
Keep the manual safe and ready for consultation for all future requirements!
ALWAYS PROVIDE CUT-OUTS SO THAT THE POWER FEEDING LINE OF THE
UNIT CAN BE DISCONNECTED FROM THE ELECTRICAL MAINS SUPPLY, EVEN IN THE
PRESENCE OF A UNIT ON/OFF CONTROL TRANSMITTED FROM THE CUSTOMER’S
REMOTE STATION.
ALWAYS DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE CARRYING
OUT MAINTENANCE!
For details, refer to the unit’s wiring diagrams.
(1) Keep the unit in a VERTICAL POSITION during loading and unloading procedures and
check that installation surface is perfectly HORIZONTAL with a spirit level;
(2) Install the unit in a place that allows proper ventilation of the condensers! Do not install
the unit indoors or in a poorly ventilated place!
(3) Do not inspect the unit electrical panel with wet or moist hands (risk of electric shock);
(4) When the unit is running do not place objects on the top (object may fall with resulting
damage to the unit and injury to operators);
(5) Maintenance must be performed ONLY by skilled personnel. When the covers of the
electrical panels or external condenser/fans compartment are opened by a maintenance
technician, other maintenance personnel or other persons in the area must be notified of
the potential hazard my means of specific warning notices!
(6) Do not use tools or objects to touch the fan impeller blades (risk of injury to persons or
damage to property or the unit).
(7) THE UNIT IS NOT SUITABLE FOR USE IN EXPLOSIVE ATMOSPHERES!
(8) The chillers are designed and approved for operation in industrial and residential
environments. For more information, consult the BICOLD Srl Engineering Department.
(9) BICOLD Srl provides one year of warranty from the date of shipment and the warranty
will be held valid only if no repairs or modifications of the unit have been carried out by
personnel not authorised by BICOLD Srl. To avoid problems, possible accidents, or injury
to persons, consult our technical personnel for authorisations for possible alterations or
refittings, repairs, removal of components or disassembly of the entire unit.
10) THE UNIT CONTAINS FLUORINATED GASES (R410A) THE GREENHOUSE
EFFECT OF WHICH IS REGULATED BY THE PROVISIONS OF THE KYOTO PROTOCOL!
(
REGULATION
842/2006/EC)
To Next Page
Loading...