3)Connection method
u Insert the three-pin plug in household tripod socket with ground.
u Gas hose connection: use dedicated gas hose(diameter Ø9mm), one end links
to roasting machine on the back of the trachea joints, air supply valve at the
other end, joint with pipe hoop banding. Gas hose mustn’t place on the
machine, skim the shell or through the bottom of the machine. Rigid bending
is not allowed either.
u Liquified petroleum gas pot must be with qualified pressure reducing
valve(rated pressure: 2800KPA), the distance between roaster and gas pot
shouldn’t less than 100cm, and the advisable hose length is 100 cm to 150
cm.
u Connected with natural gas, maximum is less than 1.2KPA), the distance
btween roaster and gas should not less than 100cm.
u Leak test: Use soap coated in the pipe joint, open the air supply valve, if
there are air bubbles, it means leak; Close the air supply valve, moderate
tone tight coupling (or nut) to try again, until the rear can be used without
any leakage.
P11
To Next Page
Loading...