（2）Pre-installation check
1)Check Item
u Power supply and plug
Using ordinary GB three-pin plug.
u Gas Pressure
Using the household low-pressure liquefied petroleum gas
u Exhaust conditions
Selecting the location of the exhaust pipe where less bends. ,if not use the existing
ventilation facilities, according to the size of the exhaust pipe to decide the
location of the hole
3) Preparation before installation roaster
1) Equipment Placement
u Baking machine placed on the flat ground.
2) Exhaust duct
u This baking equipment must be placed in a dry, well-ventilated place away
from short exhaust, ventilation ducts should not be shared with other food
machines, if used central ventilation facilities, it will cause the exhaust changes
baked
u Must have ventilation or window within one meter radius of the machine, if
ventilation is not good, it will happen worker poisoning, suffocation and other
accidents
u This device uses the exhaust pipe at Φ102mm.
P9
To Next Page
Loading...