EasyManua.ls Logo

BIEMMEDUE DR 310 - Troubleshooting and Technical Data; Troubleshooting Guide

Default Icon
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OBSERVED FAULT, POSSIBLE CAUSES AND REMEDIES
OBSERVED FAULT CAUSE REMEDY
• Check that the the switch is working and that
•
it is ON
• Check mains caracteristics (230V 1 ~ 50 Hz)
• Humidistat not set correctly
• Set the humidistat at a relative humidity level
•
which is lower than the room humidity level
•
Water tank full (pilot light (c) on) • Empty the water tank
• Check that nothing is blocking intake and
• expulsion of air
• Check that there aren’t any deposits or
• incrustation on the filter or on the ribbed
• batteries of the condenser or of the evaporator
• Room temperature and relative humidity level
• too low
• Check that the temperature is between 0°C
•
and 40°C and that relative humidity is between
• 40% and 100%
• Refrigeration circuit not working correctly • Call an Authorised Service Technician
• The unit stops and the pilot lamp (c) comes on • Water tank full • Empty the water tank
• Air flow obstructed
• Remove obstacles to air flow and start unit
• again
• Air temperature above 40°C
• Only use unit when temperature drops below
• 40°C
• Fan motor broken • Call an Authorized Service Technician
• Refrigeration circuit not working correctly • Call an Authorized Service Technician
• The unit stops and the control lamp (b) flashes • Temperature lower than 3°C
• Move the dehumidifier in a place where
• temperature is 3°C
• The unit stops and the control lamp (b)
• comes on (the condenser’s ribbed battery has
• over heated)
• The unit won’t start
•
No electricity
•
Air flow not sufficient
• The ventilator and compressor are working but
• neither water nor ice form on the walls of the
•
evaporator
15
GB