Installation, Operation and Maintenance Manual
MDE 257 Rev. 1
March 2021
11
Resticted Menu Routines
Section 3: Restricted Menu Routines
• Port 4 an0: not used
• Port 4 an1: not used
• Port 4 an2: not used
• Port 4 an3: main voltage in bits
• Port 4 an4: motor current in bits
• Port 4 an5: terminal board type in bits
• Port 4 an6: auxiliary contact of K1 contactor in bits
• Port 4 an7: current range out in bits
• Port 9 an0: auxiliary contact of K2 contactor in bits
• Port 9 an1: status of Bluetooth module in bits
• Port 9 an2: reserved. Not used for ICON3000
• Port 9 an3: motor thermostat in bits
• Port 9 an4: motor temperature in bits
• Port 9 an5: not used
• Port 9 an6: heater cmd in bits
• Port 9 an7: backlight cmd in bits
3.16.4 Reversal Delay
This function sets the delay implemented as part of the instantaneous reversal feature (i.e. reverse
motor rotation). Standard value is 1.1 seconds.
3.16.5 Backlight
The standard value is AUTO. The backlight of display automatically switches off 2 minutes after the
last operation with the local operator interface. This option increases the life of the display since the
backlight is powered only when using the local operator interface.
With the option “ON,” the backlight of the display is always powered. Use this option only when
absolutely necessary.
To Next Page
Loading...
Need help?
General
