EasyManuals Logo

BIGTREETECH TMC2130 V3.0 User Manual

BIGTREETECH TMC2130 V3.0
10 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Shen Zhen Big Tree
Technology CO.,LTD.
BIG TREE TECH
Note:
(1) When selecting SPI operation mode for hardware, please use
soldering iron carefully to avoid burns. After processing, observe
carefully whether there is residual tin residue in the module, and
clean it up to prevent short-circuit and burning of the module;
(2) Please pay attention to the wire sequence and IO port when wiring.
If the wrong wire is connected, the drive will not work.
Connect them as shown above carefully .
(3) When the driver is inserted into the motherboard, please pay
attention to see the direction of the drive, can not be inserted in
reverse, to prevent the drive from burning;
(4) Be sure to do a good job before driving heat dissipation work (heat
sink + fan), to prevent the drive is not working properly
If you have problems in use, welcome to contact us, we will be
careful to answer for you;
If you have any good comments or suggestions on our products,
please feel free to give us your feedback.
We will also carefully consider your comments or Suggestions,
thank you for choosing BIGTREETECH Product, thank you!

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BIGTREETECH TMC2130 V3.0 and is the answer not in the manual?

BIGTREETECH TMC2130 V3.0 Specifications

General IconGeneral
BrandBIGTREETECH
ModelTMC2130 V3.0
CategoryRobotics
LanguageEnglish