General Display Settings
Setting Maximum Motor Speed
Within 5 seconds of powering on the bike, hold the UP and DOWN buttons at the same time.
MXS and Km/H (MPH if you have the display set for that) will flash. Use the UP and DOWN
buttons to raise or lower the maximum motor speed where the motor will power the bike up to.
Hold the POWER button shortly to save this value and go to the next parameter.
Wheel Diameter Setting
Hold the UP or DOWN buttons to set the wheel diameter used by the controller to determine
bike speed. This does not need to be changed unless you put a different sized wheel on
the bike. Select the value in the range of 6, 8, 10, 12, 14, 16, 18, 20, 22, 24, 26, 700c and 28
inches. Hold the POWER button shortly to save and go to the next parameter.
To Next Page
Loading...
Need help?
General
