13
could pose a fire risk should the device be covered or
positioned incorrectly.
- If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified in order to
avoid a hazard.
- Do not use this heater in the immediate surroundings of a bath,
a shower or a swimming pool.
• In order to protect yourself from electric shocks, do not immerse
the plug, the power cable or the appliance in water or any other
liquid.
• If the appliance is not being used, unplug it from the mains.
• Do not touch the appliance with wet hands or feet.
• Do not move the appliance when it is in operation.
• Do not leave the appliance exposed to atmospheric conditions
(sun, rain, etc..).
• Should the appliance fall or not work correctly, disconnect the
electric cable immediately. Check that it is not damaged, and
thereafter turn it back on: if in any doubt, consult a qualified
professional.
• Do not pull on the power cable or the appliance itself to unplug
the appliance from the mains.
• Do not pull on the power cable to move the appliance.
• Do no use the appliance if it does not work properly or if it appears
damaged; when in doubt, contact a qualified technician.
• Avoid allowing the appliance to overheat; to this end, check that
the inlet and outlet are free from obstructions: do not leave
anything hanging over or under the unit. Should overheating
occur, the in-built safety device will stop the convection heater
To Next Page
Loading...
Need help?
General
