• Place the fan heater well away from other heat sources, flammable materials (curtains,
upholstery, etc.), flammable gases or explosive materials (spray cans) and materials
which may warp in heat. Ensure that gaps of at least 120 cm in front of the fan heater
and 50 cm at its sides and rear are left.
• The supporting surface must be stable, large (shelves are not acceptable), not sloping (as
the appliance might tip over), smooth and heat-proof.
Smart bowl, usable via Smartphone using an app with
or
operating systems.
• Electronics with integral wi-fi allowing Smartphone-fan heater communication via an
App.
• All functions are adjustable via APP: mode (stand-by/Auto/Eco/Rapid/Defrost);
Left/Right swing; Temperature setting 7-38°C; Timer 0-23h and Weekly
programming.
• Check that the router is for domestic use, that there are no access restrictions except
the password, that the Wi-Fi network is 2.4 GHz, and that there is a strong, uniform
Wi-Fi signal in the room where the device is to be installed.
• Make sure that the smartphone is connected to the wi-fi network to be used for the
appliance.
1.1 Install the "BIMAR life Smart" App via Google Play (Android) or AppStore (iOS), or
scan the QR code provided here.
1.7 Once installed, the app icon appears. Click the “Bimar
Live Smart” icon to run the app.
1.8 The first time the app is started, register and enter your credentials:
- click “Register” and confirm the “Privacy Policy Statement” with “I agree” to continue
- enter your phone number or email address (select the mode in the top right-hand
corner)
- click "Get check code", wait a few moments and then enter the code received in the
registration email or text message in the “Check code” field (also check in the Spam
folder if you cannot find the email in your "Incoming Mail" folder).
1.9 Enter the password required and click "Done".
1.10 A screen will open: click "Create Family".
To Next Page
Loading...
Need help?
General
