1. Fix the lower column (8) to the
base and to the counter-weight,
inserting it in its seat. Block it in
place using the L-screw (10) with
washers (12 and 11). At the end of
the operation, check that the
column and base are assembled
solidly and correctly.
2. Screw the middle column (7) onto the
lower column.
3. Screw the upper column (6)
clockwise onto the middle
column.
4. Insert the “fan head” on the upper
column so that the two holes coincide
and make certain it is blocked by
tightening the screws (5) clockwise and
making certain they are tight. At the end
of the operation, check that the fan head
and the column are assembled solidly
and correctly.
USE
Before using, check that the equipment is in good state, that the electric cord is
not damaged. If the power cord is damaged, it must be replaced by the
manufacturer of its technical service, or by a similarly qualified professional, to
prevent any and all risk.
Insert the plug into the electric socket.
Fan: select the speed desired using the dedicated keys (8):
To Next Page
Loading...
