19/60
1. Apply the 4 wheels (21) to the base (19), insert the wheels by pressing on
them and check that all 4 touch the floor.
2. Attach the "fan head" (10) and the adjustable rod (8): check that the electric
cable is in good condition and is perfectly housed inside the rod. Insert the
rod into its seat: secure it with the screw (15).
3. Unscrew the ring nut (20) on the bottom of the body if previously secured.
4. Attach the base to the main body (16):
- slightly bend the front part of the body so that the catch fits into the correct
part on the base
- place the body securely on the base so that the “ ” symbol on the base and
the “ ” symbol on the body meet
- secure with the locking ring turning counter-clockwise to tighten.
Thereafter, check that the base and main body are firmly secured.
5. Unscrew the ring nuts: secure the fan blades (4) and rear grid (6) on the motor
shaft if previously secured.
To Next Page
Loading...
