17/52
“ ” button: cools the air and evaporates micro-particles of H²O it is filled with: this
function is most effective in drier air, and is less effective as relative humidity increases (RH).
The button starts and stops the water pump. The function only takes place in the presence of
water in the tank, within the min-max values; when the water is below the min level switch
off the cooler function. It is started by pressing it “ ”.
Ventilation: the three speeds are selected by pressing the “SPEED OR " button: the
symbol corresponding to the selected speed will light up: ( = min; = med; = max).
Anti-extrusion ring “ or“ SWING ””: it is activated by pressing the button and the
“ ” control light will light up; pressing the button again deactivates it.
Mode: the three modes are selected by pressing the “MODE” o “ ”: button:
1. Normal: constant ventilation “ ”.
2. Natural: intermittent ventilation (symbol " "), like the picture shown here.
To Next Page
Loading...
