14/44
Do not allow children to replace battery.
“
” button: cools the air and evaporates micro-particles of H²O it is filled with: this
function is most effective in drier air, and is less effective as relative humidity increases
(RH). The button starts and stops the water pump. The function only takes place in the
presence of water in the tank, within the min-max values; when the water is below the
min level switch off the cooler function. It is started by pressing it “
”.
the three speeds are selected by pressing the “SPEED OR " button: the
symbol corresponding to the selected speed will light up: (LOW= min; MID= med;
HIGH= max).
“SWING/
” button, see above.
: the three modes are selected by pressing the “MODE” o “ ”: button:
1. Normal: constant ventilation “
”.
2. Natural: intermittent ventilation (symbol "
"), like the picture shown here.
To Next Page
Loading...
