13/16
If in doubt, have the appliance checked or assembled by a qualified professional
person. For assembly, refer to figure.
1) Front grille
2) Fan attachment ring nut
3) Grille attachment ring nut
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts for fasten
the grille
12) Screws
13) Handle
1) Insert the lower part of the body (7) in the base (8) (see the figure to the right),
fasten the parts using the screws provided “3” (12) and lock them in a normal way.
2) Unscrew the nuts: fan attachment (2) and rear grille (3) on the motor shaft if
3) Insert the rear grille (4) in the motor housing, so that the
handle (13) appears at the top (as figure) and position. It so
that the pins fit in their corresponding holes and lock it with
the ring nut provided (3).
4) Insert the fan (10) on the motor shaft (5), so that the slot
matches the spline. Lock using the ring nut (2), turning it
counter clockwise to tighten.
5) Couple the front grille (1) to the rear one (4) locking it with
the closing hooks. For safety reasons, you must make sure
that it is attach
ed by using the screws and nuts provided
(11), which are to be used in the holes in the edge of the
grilles (the holes for the screw must be in the lower part).
Insert the plug of the fan in the power supply.
select the desired speed with the selector (9).
1 – Minimum speed 2 – Medium speed 3 – Maximum speed
Horizontal oscillation (right-left):
this is selected with the button (6) located on the
motor body. To stop the motion and keep the ventilator still, press the button.
To Next Page
Loading...
