Attention: always unplug the appliance before you assemble.
If there are any doubts,have the operation checked or performed by qualified
professional personnel.
For assembly, refer to figure.
A. Unscrew the screw on the
rod, if already in position.
B. Position the rod (5) on the base (8) by inserting
it in its seat. Block it in place using the screw (7)
and washer (6). At the end of the operation, check
that the rod and base are assembled solidly and
correctly.
C. Unscrew the safety (10) and friction (tilt raise /lower) screws on the fan head.
D. Insert the rod in the “fan head” in the correct direction. Make certain that the
side with the slightly open slot (L, on the upper part of the rod) is on the left side.
The deeper slot (R) must be on the opposite side, that is on the right.
To Next Page
Loading...
