Introduction
Thank you for choosing Bintelli Electric Vehicles, welcome to the family. Your comfort and safety are very
important to us, we strongly recommend that you read and follow the operating instructions in this
manual, to avoid serious personal injury. Please make sure anyone operating your vehicle is familiar with
the cart's functions.
Bintelli continually seeks advancements in product design and quality, therefore, while this manual
contains the most current product information, please keep in mind there may be minor discrepancies
between your actual golf cart and this manual. If you have any questions about your vehicle, please
contact us or an authorized Bintelli dealership.
Security Statements
Please pay close attention to the statements marked as “Warning”, “Danger”, and “Caution”. If any
operating or safety warning sign on the vehicle is damaged, peeling, or blurred, it should be replaced
immediately to prevent property damage, personal injury, or death.
This vehicle is limited to a certain number of passengers (including the driver). The number of
passengers depends on the specific model, i.e. 2PR, 4PR, and 6PR.
Warning
Failure to comply with all safety warnings may cause bodily injury to the vehicle operator and/or
passengers.
- Keep the entire body
in the vehicle when in motion.
- Do not operate while
under the influence of drugs or alcohol.
- Make sure all passengers
are securely seated before driving.
- Engage the parking brake
when the cart is parked or unattended.
Danger
The batteries in your vehicle are capable of delivering large levels of power that can cause injury and
even death. For your safety, never smoke near the vehicle. It should be stored away from sparks or
flames. Only use the appropriate charger for your vehicle. When working on or near the battery, always
wear eye protection, protective clothing, and gloves.
Operating the Vehicle
Contact your local DMV for rules and regulations regarding who may legally operate the vehicle.
Switch the Tow/Run switch to the “Run” position. Make sure the Forward/Reverse switch is
switched to Neutral before switching the ignition to “On”. Do not forget to disengage the parking brake.
Once “On” switch the Forward/Reverse switch to the appropriate position.