Do not disassemble any part of the system components.
This system is not user-serviceable.
Do not place the device in liquid or put it where it could
fall into liquid.
Use the device only for the purpose described in the
instructions for use.
Do not use accessories which are not supplied or
recommended by the manufacturer.
Do not use the device if it is not working properly or if
it has suffered any damage, for example, a damaged
casing, or damage caused by dropping the equipment or
splashing water on it. Stop using the device and contact
the manufacturer.
Keep these instructions.
Do not share an outlet with another electrical device
Do not connect to an outlet controlled by a wall switch.
Do not use the device with an extension cable.
Do not use an adapter that was not supplied with the
device.
The device is designed to determine the percentage of
arterial oxygen saturation of functional hemoglobin.
Factors that may degrade pulse oximeter performance
or affect the accuracy of the measurement include the
following:
• Device not applied correctly
• Excessive motion
• Methemoglobin
• Intravascular dyes
Avoid too much light such as sunlight or bright indoor
lighting.
The device has no audible alarms and is intended for
periodic spot checking.
Clean the device between uses (See Section 8. Cleaning
and Maintenance).
Do not sterilize, autoclave, or immerse this device in liquid.
Do not pour or spray any liquids into the device.
Do not use cleaning solutions other than those
recommended, as permanent damage could result (See
Section 8. Cleaning and Maintenance).
The device should not be used as a replacement or
substitute for ECG.
Pulse rate measurement is based on the optical signal
To Next Page
Loading...