S12 Vet Monitor User’s Manual
14-3
14.5. C.O. Equipment Connecting
14.6. C.O. Measurement
14.6.1. Preparation of C.O. Measurement
1. Connecting the C.O. cable to the C.O. module or the thermistor interface
sensor port, and confirming that the C.O. measurement area is displayed on the
monitor.
2. Prepare the C.O. measurement for patients according to regulations and
procedures of the hospital department.
3. Connecting the floating catheter and other C.O. measuring accessories in
accordance with the manufacturer's manual.
4. Check that the attached accessories are functioning properly.
NOTE: For an out-line probe setup, make sure that the out-line sensor is
securely connected to the tubing.
14.6.2. Setting the C.O. Measurement
Before performing C.O. measurement, please following steps for set it up:
To Next Page
Loading...