Biolight Meditech S12 Vet - 3.6. Measurement Settings

S12 Vet Monitor User’s Manual
3-8 

If the monitor is connected to the central monitoring system, the system time of the
monitor will be automatically adjusted according to the time of the central monitoring
system.
CAUTION：
 When starting to use the monitor, please modify the date and time of the device
according to the local time. Incorrect date and time setting may lead to
misjudgment of patient trend data.
3.5.4. Adjusting Volume
Select【Sound】quick key, Set 【Alarm Volume】, 【High Alarm Volume】,
【Reminder
Volume】, 【QRSVolume】, 【TouchTone】 and 【NIBP End Tone】
switch respectively.
3.6. Measurement Settings
3.6.1. Setting Parameters
You can manually turn the parameter switch on or off. The steps to set the parameter
switch are as follows:
1. Enter【Parameter Switch】interface in one of the following ways:
 Select【Screen Setup】quick key→select 【Param Switch】submenu.
 Select【Main Menu】quick key, from【Parameter】column to select
【Parameter Switch】.
2. Turn on or off the corresponding parameters as needed
When a parameter is off, the monitor interface will not display the parameter
value and waveform.