Biolight Meditech S12 Vet - 7.6. Setting Alarm

S12 Vet Monitor User’s Manual
7-4

alarms.
 When there are multiple alarms in the same area at the same time, the alarm
messages are displayed circularly on the screen.
7.3.4. Alarm Status Symbols
In addition to the alarm methods described in section Alarm Indicators, the
following alarm icons will appear on the screen to indicate different alarm states:
Indicates an alarm for a parameter is off or the alarm system is off.
Indicates all the alarms are paused.
Indicates the alarm sound is off.
Indicates
alarms are reset.
7.4. Viewing physiological alarms list
The steps of viewing physiological alarms are as follows:
1. Selectphysiological alarms area to enter【Alarm Informations】window.
2. Select【Phy. Alarm】submenu.
7.5. Viewing technical alarms list
The steps ofviewing technical alarms list are as follows:
1. Select
technical alarms area to enter 【 Alarm Informations 】 window.
2. Select【Tec. Alarm】submenu.
7.6. Setting Alarm
You can set the alarm properties centrally. Select【Alarm Setup】quick keyor select
the corresponding button from the【Alarm】column,in the main menu to set alarm.
7.6.1. Setting Parameter Alarm
The steps to centrally set the properties of the parameter alarm are as follows:
1. Enter【Limit】interface in any of the following ways:
 Select 【Alarm Setup】 quick key.