MetaBird-v1-03/15/20 Page 27 on 30
To charge MetaBird, simply insert MetaBird’s connectors
into the charging slot of the adapter. Then connect the
cable to your smartphone charger or to a USB socket of
your computer.
The adapter LED will flash during the charge process
(about 13 min) then stop flashing when the charge is
complete.
WARNING: It is compulsory to use the plug adapter
supplied only to charge MetaBird. Any other charging
device could damage the bird battery.
In order to protect the LI-PO battery inside your
MetaBird, do not leave the bird totally discharged when
you stop using it. Before to store it, remember to charge
the bird a few minutes, and then to switch it OFF.
IMPORTANT NOTES ABOUT THE USE OF
METABIRD:
- It is strongly recommended to charge the bird at
least at 50% of the battery capacity before to store it
after use. Or the battery life will be shortened a lot.
- At cold temperature, the batteries are losing most of
their power. It may happen that your MetaBird
To Next Page
Loading...