Bionix OtoClear - Page 2

3. Attach wand onto the unit. (Fig. 4)
4. Press “Mode” key to select the mode
you desired. During irrigating, you can
change the working mode. (Fig. 5)
5. Hold the unit in an upright position with wand
tip pointed toward yourself.
6. See the ‘OtoClear Tip Instructions’ for proper
assembly of the OtoClear Tip onto the wand.
7. Press “On/O󰀨” key to start irrigating.
8. Once irrigating is completed, press“On/O󰀨” key
again to turn o󰀨 the device.
9. Remove and dispose of the single-use
OtoClear Tip.
Afterusingtheirrigator(Fig.6)
• Open the water tank cap and dispose of the
water in the tank.
• Press “On/O󰀨” key to turn on the unit, and
drain the water o󰀨 completely.
• Press “On/O󰀨” key again to turn o󰀨 the unit,
and close the water tank cap.
• Wipe the device with dry cloth.
• Press the wand release button to remove
the wand when you are nished. (Fig. 7)
Note:
To prevent bacteria propagating, make sure there
is no remaining water inside the unit. If you’re not
going to use it for a long time, be sure wipe and
dry the appliance ASAP before store it.
Maintenance
Use only water or neutral cleaning agent to clean
the device. Never use caustic or abrasive agents
(e.g: vinegar or lime scale removers), since they
may damage the device. Do not wash using hot
water of over 40ºC. Keep the device away from
high temperature area and avoid direct sunlight.
Mainunit
• Remove and the dirt clean with a liquid soap
and wipe o󰀨 using a dry cloth.
• Do not submerge the main unit in water to
clean.
• Dry after washing with water.
Watertankcap
Wipe o󰀨 any grime and dirt with a cloth.
Wand
• Wash with water and wipe with soft cloth.
• Replace the wand every 6 months.
Watersuctiontube
• Wash with water and wipe with soft cloth.
• Do not bend, pull or twist the water suction
tube.
Tank
• Wash with water and wipe with soft cloth.
• Dry the tank when not using for a long
period.
For additional Cleaning instructions, refer to
OtoClear Cleaning Instructions at bionix.com
Troubleshooting
Problem
1. It does not work
2. It only works for a few minutes even after
charging
3. Water pressure is very low
4. Water does not come out
PossibleCauses
1-1. You’ve just purchased the product or it has
been left unused for more than 3months.
2-1. The battery has reached the end of its lift
cycle.
2-2. Charging time was insu󰀩cient.
3-1. There is dirt stuck in the wand.
3-2. The wand is deformed
3-3. There is dirt stuck in the lter.
4-1. The tank is empty
4-2. The irrigator is tilted too much while in use
4-3. Valve plate slight deformation
Solution
1-1. Charge the unit for at least 4 hours.
2-1. Contact service center for support.
2-2. Charge the unit for at least 4 hours.
3-1. Replace the wand
3-2. Replace the wand
3-3. Clean the lter
4-1. Fill up tank
4-2. Use with the appliance in a vertical state
4-3. Add small amount of water to water outlet
Fig. 7
Remove
the wand
Fig. 6