Need help?Do you have a question about the biopod AQUA II and is the answer not in the manual?
Specifies what the Biopod hardware and accessories are covered for under warranty.
Shows numbered holes on the back glass for component insertion and their general purpose.
Guides on inserting stopper SY-1 into hole #4 for water-tight seals.
Details the process of inserting stoppers SY-4 into hole #3 and SY-6 into hole #5.
Guides on connecting airstone pipe and installing ventilation heating cable into stopper.
Instructs on installing the NTC sensor cable into stopper at hole #11.
Details installing the substrate heating cable into stopper at hole #10.
Explains inserting manifold pipes into holes #1 and #2 and using the manifold to push them.
Guides on connecting PUL10 elbows to manifold pipes for a water-tight seal.
Instructions for installing the living wall, with notes for Aqua/Aqua II models.
Details breaking holes in the false bottom for the One model's setup.
Explains breaking holes in false bottoms for the Terra model's setup.
Guides on fitting the broken false bottom over PLJ08 and adjusting fins.
Instructs on connecting the clear ventilation tubes to the correct vent ends.
Details using suction cups to hold ventilation tubes in place.
Guides on routing the substrate heating cable through a false bottom.
Provides notes on breaking fins, cable placement, and customizability.
Guides on attaching the Living Wall Cap to the combined living wall pieces.
Details connecting the tube from PLJ08 elbow into the living wall.
Guides on connecting the living wall tube into PUL08 for One, Terra, and Grand models.
To Next Page
General