Biostar M7VKQ User Manual

Chapter 3 Trouble Shooting
3-3
PROBLEM
Error message reading “SECTOR NOT FOUND” or other error messages will not
allow certain data to be retrieved.
PROBABLE CAUSE DIAGNOSIS SOLUTION
A number of causes
could be behind this.
Use a file by file backup
instead of an image
backup to backup the
hard disk.
Back up any salvageable
data. Then low level
format, partition, and high
level format the hard
drive. Re-install all saved
data when completed.
PROBLEM
Screen message says “Invalid Configuration” or “CMOS Failure.”
PROBABLE CAUSE DIAGNOSIS SOLUTION
Incorrect information
entered into the
configuration (setup)
program.
Check the configuration
program. Replace any
incorrect information.
Review system’s
equipment . Make sure
correct information is in
setup.
PROBLEM
Screen is blank.
PROBABLE CAUSE DIAGNOSIS SOLUTION
No power to monitor. Check the power
connectors to monitor and
to system. Make sure
monitor is connected to
display card.
Monitor not connected
to computer.
See instructions above.

Biostar M7VKQ Specifications

General

Brand	Biostar
Model	M7VKQ
Category	Motherboard
Language	English