P4M900-M7 FE/P4M890-M7 FE
3
CHAPTER 1: INTRODUCTION
1.1 BEFORE YOU START
Tha nk yo u for choosing our pro duct. Be fore you start installing the
mo the rboa rd, plea se make sure you fo llow the instructio ns be lo w:
Prepare a dry and stable working environment with
s ufficie nt ligh ting .
Always disconnect the computer from power outlet
befo re ope ra tion.
Befo re you take the mo the rboa rd ou t from a n ti -s ta tic
bag, ground yourself properly by touching any safely
grounded appliance, o r use grounded wrist strap to
remove the static charge.
Avo id tou ch ing the compone nts o n mo the rboa rd o r the
rear side of the boa rd unless necessa ry. Hold the board
on the edge, do not try to bend or flex the board.
Do no t lea ve any unfastene d sma ll pa rts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
Keep the computer from dangerous area, such as heat
source , humid a ir and wa te r.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
I ns talla tion Guide X 1
Fu lly Se tup Drive r C D X 1 (full ve rs ion manua l files ins ide )
Rear I/O Panel for ATX Case X 1
FDD Cable X 1 (optional)
Se ria l ATA Cab le X 1 (op tiona l)
USB 2.0 Cable X1 (optional)
Se ria l ATA Po we r Cab le X 1 (o ptio nal)
Note: The package contents may differ by area or your motherboard version.
To Next Page
Loading...
Need help?
General
