Chapter One Safety Instruction And Labels
1、Safety Instruction
1. Training
a) Read the instructions carefully. Be familiar with the controls and the proper use of the
equipment;
b) Never allow children or people unfamiliar with these instructions to use the machine. Local
regulations can restrict the age of the operator;
c) Never work while people, especially children, or pets are nearby;
d) Keep in mind that the operator or user is responsible for accidents or hazards occurring to
other people or their property.
2. Preparation
a) While working, always wear substantial footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals;
b) Thoroughly inspect the area where the equipment is to be used and remove all objects which
can be thrown up by the machine;
c) WARNING – Petrol is highly flammable:
- Store fuel in container specifically designed for this purpose;
- Refuel outdoors only and do not smoke while refueling;
- add fuel before starting the engine. Never remove the cap of the fuel tank or add petrol while
the engine is running or when the engine is hot;
- if petrol is spilled, do not attempt to start the engine but move the machine away from the area
of spillage and avoid creating any source of ignition until petrol vapours have dissipated;
- replace all fuel tank and container caps securely;
d) Replace faulty silencers;
e) Before using, always visually inspect to see that the tools are not worn or damaged. Replace
worn or damaged elements and bolts in sets to preserve balance.
3. Operation
a) Do not operate the engine in a confined space where dangerous carbon monoxide fumes can
collect;
b) Work only in daylight or in good artificial light;
c) Always be sure of your footing on slopes;
d) Walk, never run with the machine;
e) Exercise extreme caution when changing direction on slopes;
f) Do not work on excessively steep slopes;
g) Use extreme caution when reversing or pulling the machine towards you;
h) Do not change the engine governor settings or overspeed the engine;
i) start the engine carefully according to manufacturer instructions and with feet well away from
the tool(s);
j) When start the engine, ensure the Gearshift in neutral position. Do not put hands or feet near
or
under rotating parts;
k) Never pick up or carry a machine while the engine is running;
l) Stop the engine:
- Whenever you leave the machine;
- Before refueling;
m) Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-
off valve, turn the fuel off at the conclusion of working;
n) Never load person, when starting at cobbled road、sidewalk or on the rode, pls keep watch,
note the traffic situation in case of the potential dangers!
0) Once abnormal condition happens, immediately close the engine! Look for the reason,
vibration is often the beginning of the fault
p) When tilling in the hard land, the blades may lowing the ground, be more careful. If
happens, go off the handle bar and not go to control machine
4. Maintenance and storage
a) Keep all nuts, bolts and screws tight to ensure the equipment is in safe working condition;
b) Never store the equipment with petrol in the tank inside a building where fumes can reach an
Italia Star Com Due S.R.L.
To Next Page
Loading...