Bissell CLEANVIEW 2383 Series - Maintenance: Pre-Motor Filter; Maintenance: Post-Motor Filter

Maintenance: Pre-Motor Filter
Maintenance: Post-Motor Filter
www.BISSELL.com
8
1
2
3
4
Return tank back
on vacuum and
press firmly until
you hear “click”.
Remove foam
filter from tray.
Hand wash in
warm water;
mild detergent
may be used if
desired. Rinse well
and then air dry
thoroughly.
Make sure filter
is completely dry
before placing back
into the tank lid.
Close the lid to
return the tank to
the vacuum.
1
2
Firmly pull filter tray out.
Push pleated filter
down through filter
tray.
NOTE:
If dust and/or debris
accumulates on the
filter, gently tap the
filter on the side of
a garbage container.
WARNING
Do not operate vacuum with damp or wet filters
or without all filters in place.
Press tank
release button
and remove
dirt tank.
To access filter,
Press the Filter
button on
front.
click
NOTE: The pleated post-motor filter may NOT be washed with water or detergent. Replace the
post-motor filter every 3 to 6 months.