If you got a Bitronics kit and need help
to build & flash the firmware follow the
full guide scaning the QR code
NERDMINERv2
2 - On the following screen (1), use
your phone to scan for Wi-Fi networks
and connect to NerdMinerAP with
password MineYourCoins.
3 - Once connected, the following
menu will be shown (2).
Click on Configure Wifi to setup.
TOOLS
NEEDED
Required time: 5 minutes
Required time: 20 minutes
WiFi/Password: network
credentials were you want to
connect to.
Pool url/port: introduce your
pool settings or leave default
BTC address: BTC address
where you will receive prize.
TimeZone: set your timezone
from UTC to display correct
time.
4 - Setup miner parameters:
For any problem check full guide or
contact Bitronics team.
To Next Page
Loading...