Instruction manual NSF VSI / VSI W / VSI T / VSI
TW Machine and operating elements
38065447002 en-US 43 / 101
In case of many layers, the max. stack height could be exceeded without
the machine switching off. In this case, the number of layers has to be
manually reduced.
Several parameters influence the look of the depositing pattern:
Fig.19: Circular pattern default values
Depositing offset lengthwise
Depositing offset crosswise
Circular diameter
Number of slices in the circle
Number of layers circular pattern
Product height
Product width
By adjusting the distance of slices, the number of slices for each circle are distributed evenly.
Target weight:
The target weight refers always to one layer.
If circular pattern is active, the anchor must always be set to number of slices. The tile num-
ber of slices is grayed out and displayed with lock icon and anchor.
The tile slice thickness is grayed out and displayed with lock icon. The device automatically
sets the slice thickness possible in order to reach the target weight.
To Next Page
Loading...
Need help?
General
