1.
Connect the high pressure hose (E)
to the machine outlet (K). Ensure
the threads are aligned properly
and the connection is secure.
4.
Turn incoming water on and fully
open valve to insure maximum
water flow to machine.
O
2.
Connect the garden hose (Y)to the
connector (D) on the front of the
machine. Before connecting, run
water through the garden hose (not
supplied) to flush out any foreign
matter.
NOTE: If your water source is a
well, the garden hose length can
only be 30 ft. maximum.
5.
Plug GFCI (C)into power receptacle.
Firmly press and release the TEST
button (Z), then press and release
the RESET button (Y). The light on
the GFCI should be illuminated.
3. Insert the spray lance (B, R) into
the gun (A) by pushing firmly and
simultaneously twisting a 1/4 of a
turn counterclockwise until locked
into place.
@
Z_ WARNING: If the lance is not
securely locked into place, it could
be ejected under high pressure during
operation, possibly causing injury or
damage.
6. Ensure the gun safety is unlocked
and squeeze the trigger until the air
has escaped and a steady flow of
low pressure water is coming from
the nozzle.
7.
12- ENG
Turn switch to ON position (I).Note
that the motor will momentarily
start then stop.
O
To Next Page
Loading...
