Z_ CAUTION: Prior to moving the unit,
always disconnect the garden hose via
the garden hose connector.
Z_ CAUTION: Always store your
pressure washer in a location where
the temperature will not fall below 40° F
(4° C). The pump in this machine is
susceptible to permanent damage if
frozen. FREEZE DAMAGE IS NOT
COVERED BY THE WARRANTY.
END OF USE AND WINTER
STORAGE INSTRUCTIONS
1. When finished using the pressure
washer, you must first drain and
rinse the detergent tank.
2. Run the pressure washer in low
pressure until all of the soap is
drained from the detergent tank.
3. Pour clear water into the tank and
run it through on low pressure as
though it were detergent.
NOTICE: Failure to clean properly will
cause bottle or suction tube to become
clogged and inoperable.
4. Turn the machine OFF and squeeze
the trigger to release the trapped
pressure inside of the machine.
5. Remove both the garden hose and
high pressure hose from the unit.
6. Disconnect the lance from the gun.
7. Turn ON the machine and allow it
to run for 5 seconds. (This will clear
out most of the water trapped in
the pump).
8. Unplug machine.
9. Wrap high pressure hose and
power supply cord onto storage
rack and snap power supply cord
into place as shown.
10. Store the machine and accessories
in a dry, climate controlled
environment. Do not store the
machine or accessories in a place
where the temperature could drop
below 40° F (4° C).
z_ DANGER: Risk of fluid injection.
When using replacement lances or
guns with this pressure washer, DO
NOT use a lance and/or lance/gun
combination that is shorter in length
than what was provided with this
pressure washer as measured from
the nozzle end of the lance to the
gun trigger.
NOTICE: The use of any other
accessory not recommended for use
with this tool could be hazardous.
Use only accessories rated equal
to or greater than the rating of the
pressure washer.
14- ENG
To Next Page
Loading...
