Labels on your tool
They may include the following symbols.
V ............. volts
A ............. Amperes
Hz ............. Hertz
W ............. Watts
Min. ............. Minutes
............. Alternating current
............. Direct current
no ............. No load speed
............. Class II Construction
............. Earthing terminal
............. Safety alert symbol
.../min ............. Revolutions or reciprocation per minute
.../bpm ............. Beats per minute
Save these instructions!
Electrical safety
Your charger is double insulated; therefore no earth wire is required. Always check
that the mains voltage corresponds to the voltage on the rating plate. Never attempt to
replace the charger unit with a regular mains plug.
Using an Extension Cable
An extension cable should not be used unless absolutely necessary. Use of an improper
extension cable could result in a risk of fire and electric shock. If an extension cable must be
used, use only those that are approved by the country’s Electrical Authority. Make sure that
extension cord is in good condition before using. Always use the cord that is suitable for the
power input of your charger (see technical data on name plate).
When using a cable reel, always unwind the cable completely.
To Next Page
Loading...
