Black & Decker BPT10WTB - Follow Me and Timer Programming

Page 24
FOLLOW ME
Parts of the room are cooler where there is a draft. Other parts are warmer due
to direct sunlight. The FOLLOW ME Function allows the room to be cooled
according to the room temperature, wherever the remote is located.
• This function can be activated from the remote control ONLY. The remote
control serves as a thermostat allowing for the precise temperature control at
its location.
• To activate the Follow Me function, point the remote control towards the
appliance and press the FUNCTION
button.
• Press either the
OR button until the FOLLOW ME symbol ashes on
the LED screen.
• Press the Menu
button. The FOLLOW ME will stop ashing and illuminate
on the LED screen.
• The remote will display the actual temperature at its location. The remote
control will send this signal to the air conditioner at 20 minute intervals.
• If the unit does not receive the Follow Me/Temp Sensing signal during a 25
minutes interval, the follow me function will be canceled and will need to be
reactivated.
NOTE: · The remote must be within 23 feet of the remote control receiver on the
air conditioner unit. It should not have any obstructions.
• To cancel this function, press the
, then press either the or button
until the
ashes onscreen, and then press the button to conrm the
cancellation. The
will stop ashing and disappear from the screen.
TIMER
BUTTON
• The timer can be used to delay the appliance start-up or shutdown.
PROGRAMMING START-UP
• With the appliance ON select the settings that you would like to program
at start-up. Example: COOL Mode, temperature, fan speed. Turn OFF the air
conditioner.
• Press the
button twice, the LED screen will display hours, the symbol and
symbol will flash .
• Press the
or button to set the time when you want the appliance to
switch on using the buttons (from 30 minutes to 24 hours).
• During the first ten hours you can select half hour intervals. For times longer
than ten hours, one hour intervals can be selected.
• Press the
button again to activate the selected time. The symbol and
will be displayed on the LED screen
. Remaining time will be displayed
on the LED screen
SET UP & USE