Black & Decker BPT10WTB - Water Drainage in Dehumidification Mode

Continuous Draining for Dehumidication Mode.
Unplug the unit from the power source.
Remove the drain cap located in the back center of the unit. While doing this
operation some residual water may spill so have a drip pan (not supplied) to
collect the water.
Connect the drain hose (supplied) as shown in the diagram. The water can be
continuously drained through the hose into a oor drain or bucket.
Turn on the unit.
NOTE: The supplied drain hose can be substituted with a standard garden hose
for middle drainage only.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
• After the unit has stopped, it cannot be restarted for 3 minutes. Operation will
automatically restart after 3 minutes.
SET UP & USE
Page 28
Garden hose
or drain hose