7
OVERVIEW (FIG. 5)
2. Main handle
6. Saw blade lower guard
8. Saw blade spanner wrench
10. Outer blade clamp washer
11. Blade retaining bolt
ASSEMBLY / ADJUSTMENT SET-P
WARNING: Always unplug saw from
power supply before any of the following
operations.
ADJUSTING THE DEPTH OF CUT (FIG. 6 & 7)
The depth of cut should be set according
shoe.
position. The corresponding depth of
in place.
one tooth of the blade projects below
gure7.
ADJUSTING THE BEVEL ANGLE (FIG. 8)
This tool can be set to bevel angles
the saw shoe.
position. The corresponding bevel
saw shoe in place.
ATTACHING THE BLADE (FIG. 9 & 10)
Loosen and remove the blade
the arrow on the blade points in the
same direction as the arrow on the upper
gaurd of the tool.
with
the larger flat surface against the blade.
into the hole in the spindle.
7
Tip of tooth
Surface of wood
6
12
8
5
1
2
6
8
10
11
To Next Page
Loading...
