Black & Decker Digital Evolution D5000 - Page 4

HowtoUse
This appliance is intended for household use only.
GETTINGSTARTED
Remove any labels, stickers or tags attached to the body or soleplate of the iron.
Note: Use ordinary tap water for ironing. Do not use water processed through a home
softening system.
Important: For optimum performance, let the iron stand for 90 seconds before beginning to
iron.
FillingWaterTank
1. Grip each side of the water-fill cover and pull open (B).
2. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the MAX level mark on the
water tank (C). Do not overfill.
3. Close the water-fill cover.
Note: If you need to add water while ironing, unplug the iron and
follow above steps.
4. Plug the iron into an electrical outlet.
• The iron beeps.
• Digital display window illuminates and fabric setting
1 (ACRYL) displays on the window with a flashing up
arrowand a circle around the iron symbol (D).
5. Once the iron reaches the preset temperature, it beeps and
the display shows the set temperature, fabric type and the iron
symbol without the circle (E).
SELECTINGFABRICTEMPERATURE
1. Read garment's label to help you determine fabric type.
Tip: If unsure of a garment's fiber, test a small area (on an inside
seam or hem) before ironing.
2. Once you determine the fabric type, select appropriate
temperature setting (from 1 to 7).
Tosetfabrictemperature:
1. Use the pushbuttons on either side of the digital display
window (F).
2. Press the (+) button to select a higher setting.
3. Press the (-) button to select a lower setting.
Tip: As a guide, the digital display shows the setting number with
the corresponding fabric type.
65
0
FEATURES
AUTO OFF LOW TEMP HIGH TEMP
SELF CLEAN STANDBY
READY
FABRIC NO.
TEMP
UP/DOWN
FABRIC NAME
LCDDisplaySymbols
B
C
D
E
F
Surge-of-Steam
Spray
AutoOff
Symbols