Functional Description
1. Blade
2. Guard
3. Bail Handle
4. Lock Button
5. Trigger Switch
6. Rotate Button
7. Pigtail Cord / Cord Retainer
4
1
2
3
4
5
6
7
Symbols
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts A ...................amperes
Hz ................hertz W .................. watts
min ..............minutes
or AC .......alternating current
or DC ...direct current
n
o .................no load speed
................Class I Construction .................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction .../min or rpm...revolutions or
(double insulated) reciprocation per minute
bpm ............. beats per minute .................. Use proper respiratory
protection
............
Read instruction manual before use
.................Use proper eye protection
................Use proper hearing protection
EXTENSION CORDS
When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more American Wire Gage
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended
To Next Page
Loading...
