Black & Decker MS2000 - Random Orbit Sanding Base; Attaching Random Orbit Base; Fitting Sanding Sheets; Large Detail Sanding Base

Random orbit sanding base
With this sanding base, you can use the tool as a random orbit sander.
Attaching the random orbit
sanding base - Figure C
• Hold the tool and the sanding base (4)
facing upwards as shown in figure C.
• Align the dust openings (9) in the sanding
base with the dust openings (10) in the
tool base.
• Press in on the sanding base until you
hear it click into place.
Fitting sanding sheets - Figure D
• Hold the tool with the sanding base (4)
facing upwards.
• Place the sanding sheet (11) onto the
sanding base (4) making sure the holes in
the sheet line up with the holes in the base.
Large detail sanding base
With this sanding base, you can use the tool
as a detail sander or a flush sander.
Attaching the large detail sanding
base - Figures E & F
For detail sanding, the pointed end should
face forward as in figure E.
For sanding large areas, the pointed end
should face to the back as in figure F.
• Attach the sanding base as described
above under “Attaching the random orbit
sanding base”
• Press in on the sanding base until you
hear it click into place.
7
C
4
9
9
10
4
11
D
E
F