27
ENGLISH
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center.
WARNING! The use of any accessory not recommended for use with this tool could be
hazardous.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and authorized service locations.
All Black & Decker Service Centers are staffed with trained personnel to provide customers with
efficient and reliable power tool service. For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory replacement parts, contact the
Black & Decker location nearest you, or visit us at www.BlackandDecker-la.com
TROUBLESHOOTING
Problem Possible cause Possible Solution
• Tool will not charge. • Charger not plugged into • Plug charger into a
a working outlet. working outlet. Refer to
“Important Charging
Notes” for more details.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is connected
to a light switch which
turns power off when
you turn out the lights.
• Surrounding air temperature • Move charger and tool
too hot or too cold. to a surrounding air
temperature of above
40 degree F (4,5°C)
or below 105 degree
F (+40,5°C).
SPECIFICATIONS
Voltage 3.6V 4.8V
Speed 180/min 180/min
Torque 40in-lbs (4.6Nm) 40in-lbs (4.6Nm)
Charging Time 30h 30h
Input
AR 220V ~ 50Hz 30mA 220V ~ 50Hz 10mA
B2C 220V ~ 50-60Hz 30mA 220V ~ 50-60Hz 30mA
B3 120V ~ 60Hz 5W 120V ~ 60Hz 5W
BR 127V/220V ~ 50-60Hz 30mA 127V/220V ~ 50-60Hz 30mA
Output
AR 4V ~ 100mA 5.8V ~ 40mA
B2C 4.5V ~ 80mA 5.8V ~ 40mA
B3 4,2V CA/AC 100mA 5V CA/AC 100 mA
BR 4V ~ 100mA 5.8V ~ 40mA
Charger PD400L PD500C
Screwdriver PD400L PD500C
To Next Page
Loading...
