Black & Decker VM2040 - Vacuuming Operations; Adjusting Controls; Starting and Stopping; Usage Tips and Handling

English
Adjusting the tube length (fig. F)
The extension tube (7) can be adjusted as
follows:
• Push the knob (20) and slide the tube to
the desired length.
• Release the knob.
Adjusting the suction head (fig. D)
• For vacuuming on carpets, switch the
brush actuator (21) into the up position.
• For vacuuming on laminates, tiles, etc.,
switch the brush actuator into the down
position.
Switching on and off
The on/off switch (1) can be operated by
hand or foot.
• To switch the appliance on, press the
on/off switch (1).
• To switch the appliance off, press the
on/off switch again.
Setting the suction force
The speed control selector (3) allows for a
precise setting of the suction force. For
vacuuming on a hard surface (e.g. floors),
choose a high speed setting. For
vacuuming on soft surfaces (e.g.
upholstery), choose a low speed setting.
• Slide the speed control selector to the
desired setting.
Adjusting the airflow (fig. G)
Move the airflow control switch (6) to adjust
the airflow as desired.
Vacuuming
• When operating the appliance, make
sure that the hose is not trapped,
twisted or blocked.
• In case of overheating, a cut-out will
operate and the appliance will
automatically stop.
• If the appliance stops operating, unplug
the appliance and allow it to cool for 2-3
hours before continuing. Ensure the
filters are cleaned and the unit is
blockage free before switching back on.
Hints for optimum use
• When vacuuming stairs, always start at
the bottom and work your way up.
Position the appliance on the floor and
do the stairs until halfway. Then carry the
appliance to a stable position which is at
least one stair below your working
position, and do the top half of the stairs.
Carrying the appliance
During use the appliance can be carried
using the handle (4).
Temporarily parking the suction head
(fig. H)
• Use the park position (22) for a
temporary parking of the suction head.
Storing the appliance (fig. I)
Warning! When storing the appliance,
switch the appliance off and unplug it.
• Make sure that the cord is fully rewound.
• Place the appliance in an upright
position.
• Park the tube in the park position (23).
• Store the appliance in a dry location.
Maintenance
Your Black & Decker appliance has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation depends
upon proper appliance care and regular
cleaning.
Warning! Before performing any
maintenance or cleaning on the appliance,
unplug the appliance.