103
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
Rv: Robustness Variable. The Robustness Variable allows tuning for the expected packet loss on a network. The allowed range is 1 to
255; default robustness variable value is 2.
QI: Query Interval. The Query Interval is the interval between General Queries sent by the Querier. The allowed range is 1 to 31744
seconds; default query interval is 125 seconds.
QRI: Query Response Interval. The Max Response Time used to calculate the Max Resp Code inserted into the periodic General
Queries. The allowed range is 0 to 31744 in tenths of seconds; default query response interval is 100 in tenths of seconds (10
seconds).
LLQI (LMQI for IGMP): Last Member Query Interval. The Last Member Query Time is the time value represented by the Last Member
Query Interval, multiplied by the Last Member Query Count. The allowed range is 0 to 31744 in tenths of seconds; default last member
query interval is 10 in tenths of seconds (1 second).
URI Unsolicited Report Interval. The Unsolicited Report Interval is the time between repetitions of a host’s initial report of membership
in a group. The allowed range is 0 to 31744 seconds; default unsolicited report interval is 1 second.
Buttons:
- Apply – Click to save changes.
- Reset - Click to undo any changes made locally and revert to previously saved values.
Upper right icon (Refresh, |<<, >>): Click to Refresh the displayed table starting from the “VLAN” input fields. Or click “|<<” to update the
table starting from the first entry in the VLAN table, i.e. the entry with the lowest VLAN ID. Click “>> “ to update the table, starting with
the entry after the last entry currently displayed.
3.11.2.3 PORT GROUP FILTERING
The section describes how to set the Port Group Filtering in the MLD Snooping function. On the UI, you can add a new filtering group and
safety policy.
WEB INTERFACE
To configure the MLD Snooping Port Group Configuration in the web interface:
1. Click Configuration, IPMC, MLD Snooping, Port Group Filtering Configuration.
2. Click Add new Filtering Group.
3. Specify the Filtering Groups with entries per page.
4. Click Apply to save the setting.
5. To cancel the setting, click the Reset button. It will revert to previously saved values.
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
