114
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
3.14 VLANS
You can assign a specific VLAN for management purposes. The management VLAN is used to establish an IP connection to the
switch from a workstation connected to a port in the VLAN. This connection supports a VSM, SNMP, and Telnet session. By default,
the active management VLAN is VLAN 1, but you can designate any VLAN as the management VLAN using the Management VLAN
window. Only one management VLAN can be active at a time.
When you specify a new management VLAN, your HTTP connection to the old management VLAN is lost. For this reason, you
should have a connection between your management station and a port in the new management VLAN or connect to the new
management VLAN through a multi-VLAN route.
WEB INTERFACE
To configure VLAN membership configuration in the web interface:
1. Click Configuration VLANs.
2. Specify Existing VLANs, Ether type for Custom S-ports.
3. Click Apply.
FIGURE 3-68. VLAN CONFIGURATION SCREEN
Parameter description:
Global VLAN Configuration
Existing VLANs: This field shows the VLANs that are created on the switch.
By default, only VLAN 1 exists. More VLANs may be created by using a list syntax where the individual elements are separated by
commas. Ranges are specified with a dash separating the lower and upper bound.
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
