12
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
CHAPTER 3: SYSTEM CONFIGURATION
3.1.2 IP
The IPv4 address for the switch can be obtained via DHCP Server for VLAN 1. To manually configure an address, you need to
change the switch’s default settings to values that are compatible with your network. You may also need to establish a default
gateway between the switch and management stations that exist on another network segment.
Configure the switch-managed IP information on this page.
Configure IP basic settings, control IP interfaces and IP routes.
The maximum number of interfaces supported is 8 and the maximum number of routes is 32.
WEB INTERFACE
To configure an IP address in the web interface:
1. Click Configuration, System, IP.
2. Click Add Interface, then you can create new Interface on the switch.
3. Click Add Route, then you can create new Route on the switch.
4. Click Apply.
FIGURE 3-2. IP CONFIGURATION SCREEN
To Next Page
Loading...
