Black Box LGB1126A-R2 - DSCP Translation

139
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
3.18.8 DSCP TRANSLATION
The section describes how to configure the basic QoS DSCP Translation settings for all switches. DSCP translation can be done in
Ingress or Egress.
WEB INTERFACE
To configure the DSCP Translation parameters in the web interface:
1. Click Configuration, QoS, DSCP Translation.
2. Scroll to set the Ingress Translate and Egress Remap DP0 and Remap DP1 Parameters.
3. Enable or disable Classify.
4. Click save to save the setting.
5. To cancel the setting, click the Reset button. It will revert to previously saved values.
FIGURE 3-87. DSCP TRANSLATION CONFIGURATION SCREEN
Parameter description:
 DSCP: Maximum number of supported DSCP values are 64 and valid DSCP value ranges from 0 to 63.
 Ingress: Ingress side DSCP can be first translated to new DSCP before using the DSCP for QoS class and DPL map.
There are two configuration parameters for DSCP Translation.
1. Translate: DSCP at Ingress side can be translated to any of (0–63) DSCP values.
2. Classify: Click to enable Classification at the Ingress side.
 Egress: There are the following configurable parameters for Egress side.
1. Remap DP0: Select the DSCP value you want to remap from. DSCP values range from 0 to 63.
2. Remap DP1: Select the DSCP value from select menu to which you want to remap. DSCP values range from 0 to 63.
 Remap: Select the DSCP value from the menu to which you want to remap. DSCP values range from 0 to 63.
CHAPTER 3: SYSTEM CONFIGURATION