144
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
Action Configuration: Class QoS Class: “class (0-7)”, default- basic classification. DP Valid DP Level can be (0-3)”, default- basic
classification. DSCP Valid dscp value can be (0-63, BE, CS1-CS7, EF or AF11-AF43)
Buttons:
- Apply – Click to save changes.
- Reset- Click to undo any changes made locally and revert to previously saved values.
3.18.11 STORM CONTROL
This section explains how to configure the Storm control for the switch. There is a unicast storm rate control, multicast storm rate
control, and a broadcast storm rate control. These only affect flooded frames, i.e. frames with a (VLAN ID, DMAC) pair not present on
the MAC Address table. The configuration indicates the permitted packet rate for unicast, multicast, or broadcast traffic across the
switch.
WEB INTERFACE
To configure the Storm Control Configuration parameters in the web interface:
1. Click Configuration, QoS, Storm Control Configuration.
2. Select the frame type to enable storm control.
3. Scroll to set the Rate Parameters.
4. Click save to save the setting.
5. To cancel the setting, click the Reset button. It will revert to previously saved values.
FIGURE 3-90. STORM CONTROL CONFIGURATION SCREEN
Parameter description:
Frame Type: The settings in a particular row apply to the frame type listed here: Unicast, Multicast, or Broadcast.
Enable: Enable or disable the storm control status for the given frame type.
Rate: The rate unit is packets per second (pps). Valid values are: 1, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1K, 2K, 4K, 8K, 16K, 32K, 64K, 128K,
256K, 512K or 1024K. , 1024K, 2048K, 4096K, 8192K, 16384K or 32768K. , 1024K, 2048K, 4096K, 8192K, 16384K or 32768K.
NOTE: The 1 kpps is actually 1002.1 pps.
Buttons:
- Apply – Click to save changes.
- Reset - Click to undo any changes made locally and revert to previously saved values.
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
