152
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LE AVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 7 7. 8 7 7. 2 26 9
3.23 SWITCH2GO
3.23.1 SWITCH2GO SETTING
Configure Switch2go management and link setting.
WEB INTERFACE
To configure Switch2go setting in the web interface:
1. Click Configuration, Switch2go, and and Switch2go setting.
2. Set the parameters.
3. Click Apply.
FIGURE 3-97. SWITCH2GO SETTING SCREEN
Parameter description:
Management mode: Indicates the Management mode operation. When the mode operation is enabled, the message will send out
to (or get from) the server. The protocol is based on TCP communication and received on TCP port 443 and the server will send
acknowledgments/information back to the sender since TCP is a connection-oriented protocol. Possible modes are:
- Enabled: Enable Switch2go Management mode operation.
- Disabled: Disable Switch2go Management mode operation.
Server Address: Indicates the IPv4 host address of the server. If the switch provides the DNS feature, it also can be a host name.
Server State: Report network information between the Switch and Server.
Link Option: Indicates the Link Option operation.
When the Link Option is Automatic, enabling applications access the services provided by an UPnP “Internet Gateway Device
(IGN)” present on the network.
When the Link Option is Manual, you should set Setting External Port and Your IGN/NAT’s Port Forward function manually.
When Link function is working successfully, Mobile(s) can access this NAT by Internet.
Possible modes are:
- Automatic: Link Option is Automatic.
CHAPTER 3: SYSTEM CONFIGURATION
To Next Page
Loading...
